Please always remember that thes very thin and fragile and even small deformations it breaks down.
It's important to know, that some manufacturers of in different series of devices can install different models of screens. Before ordering the screen disassemble your machine and verify in the valdity of data of the table. It's necessary!
Be attentive when you order a new screen as displays with additional functions of backlight and sensor have the same markings as displays without these functions. The only difference is the appearance - the number of flexible cables. Compare the photo in the site of the shop with the screen of your machine.
Remember that the replacement screen is hard work and if you are not confident in their abilities, it is best to contact your service center. The authors are not responsible for your actions in implementing the recommendations written on the page.
Before replacing the screen to make out an, take off her old (damaged) screen and find on a flexible cable marking model. This marking is necessary to order a new screen. You can contact us to help you check the model marking. Just enter the screen model in the search box of any search engine and choose a favorite spare parts.
If the shell halves are held reader to snap, leaving no scratches on them, instead of a screwdriver Expand the joint between the plastic card. After the back cover is opened to disconnect . Next, the loosen connector lock loop flexible display by hooking on both sides of a thin screw driver. Now disable the ribbon cable from the connector. Then, the printed circuit board can be removed for access to the display.
In some models of the display is glued tocircuit board and it has to literally "scrub away" bit by bit. Shards of broken glass screen are very acute and thin. It is better to use thin gloves when you are working, so as not to cut your hands.
Before installing the new display with base concrete must be removed all the broken glass, dust and other foreign objects. Any piece of glass or even a grain of sand that gets between the main circuit board unit and the screen can cause it to faults again.